This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
specular [2014/11/26 09:37] adavies |
specular [2014/11/28 05:56] adavies removed |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Specular ====== | ====== Specular ====== | ||
+ | |||
+ | Short paragraph explaining the function of the Specular stuff here, along with a nice picture for eye candy. | ||
===== The Specular Group's Interface ===== | ===== The Specular Group's Interface ===== | ||
Line 9: | Line 11: | ||
* **Gaussian:** | * **Gaussian:** | ||
* **GGX:** | * **GGX:** | ||
+ | |||
+ | |||
**Power Drop:** The ramp used by Lys to dictate the convolution amount on a per MIP basis. You can choose between the various power drops listed below. | **Power Drop:** The ramp used by Lys to dictate the convolution amount on a per MIP basis. You can choose between the various power drops listed below. | ||
* **Default:** The standard ramp used by Lys. This ramp is the inverse of the one found within Marmoset Toolbag 2 with adjusted constants. | * **Default:** The standard ramp used by Lys. This ramp is the inverse of the one found within Marmoset Toolbag 2 with adjusted constants. | ||
* **Log2:** A user configurable ramp that allows variable distribution of specular power values across MIP levels. | * **Log2:** A user configurable ramp that allows variable distribution of specular power values across MIP levels. | ||
- | **Use Specular Power:** | ||
- | **Roughness/Spec. Power:** Check this to enable Lys to work with specular power rather than roughness. | + | |
+ | **Use Specular Power/Use Roughness:** Check this to enable Lys to work with specular power rather than roughness & vice versa. | ||
**MIP Offset:** This value represents an offset from the bottom 1x1 cube map MIP level. The default value of 3 corresponds to assigning a specular power of 1 to level 8x8. | **MIP Offset:** This value represents an offset from the bottom 1x1 cube map MIP level. The default value of 3 corresponds to assigning a specular power of 1 to level 8x8. | ||
Line 77: | Line 81: | ||
- | ==== The Log2 Power Drop ==== | + | === The Log2 Power Drop === |
Line 120: | Line 124: | ||
- | ==== Specular Power Distrubution across Mip Map Levels ==== | + | === Specular Power Distrubution across Mip Map Levels === |
[{{:specular_power_plot.png?nolink|The figure shows the specular power distributions for 3 different userscales where top level is 128x128 and nMipOffset is set to 3. | [{{:specular_power_plot.png?nolink|The figure shows the specular power distributions for 3 different userscales where top level is 128x128 and nMipOffset is set to 3. | ||
Line 130: | Line 134: | ||
- | ==== The Default Power Drop ==== | + | === The Default Power Drop === |