This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
the_baker_knald_1.1 [2016/03/13 23:14] adavies [Ray Projection Settings] |
the_baker_knald_1.1 [2016/03/13 23:14] adavies [Ray Projection Settings] |
||
---|---|---|---|
Line 60: | Line 60: | ||
- | **Push:** The amount you wish to inflate the projection cage. The projection cage should in most instances completly enclose the High Poly mesh in order to render correctly. | + | **Push:** The amount you wish to inflate the projection cage. The projection cage should in most instances completely enclose the High Poly mesh in order to render correctly. |
**Range:** The amount you wish to inflate the range cage. This should be set at a distance that is as close to the High Poly mesh as possible, while still being enclosed by it. Setting this value too high can cause unnecessary increases in render times. See the images below for more details. | **Range:** The amount you wish to inflate the range cage. This should be set at a distance that is as close to the High Poly mesh as possible, while still being enclosed by it. Setting this value too high can cause unnecessary increases in render times. See the images below for more details. |